Help Center
Type your question Or Choose a category to find the help you need
Stuck in place - for Robomow professional dealers only
Error Message | Model | Description | Problem Cause | Corrective Action |
Stuck in place (24) | RS/MS RC/MC |
More than 10 consecutive slippage events detected | Check the front wheel can rotate freely on its axle and against the robot’s chassis | |
Stuck In Place (57) | RC/MC | Stuck in place without the ability to move more than 100 seconds | Check the lawn for no obstacles, or holes in the ground that eliminate the drive wheels to rotate freely | |
Stuck In Place (59) (64) | RS/MS RC/MC |
robot is trapped and performed more than 100 consecutive short legs (legs with distance shorter then 150 cm) | Such scenarios can happen for example when robot gets trapped in a certain area where it is surrounded by many obstacles. Another example is trapping inside a narrow path without ability to exit out. | Check the lawn for no obstacles, or holes in the ground that eliminate the robot move freely. If this happen inside a narrow path area, add a perimeter island to eliminate the robot to drive into this area while mowing. Watch the below link: For RS / MS: How to set a Narrow Pass installation For RC / MC: How to set a Narrow Pass installation |
Stuck In Place (61) Stuck on the wire (44) |
RS/MS RC/MC |
Robot is stuck on the wire after 5 rescue behavior retries without success. | Such scenarios can happen for example when robot gets trapped in a certain area where it is surrounded by many obstacles. Another example is trapping inside a narrow path without ability to exit out. | Check the lawn for no obstacles, or holes in the ground that eliminate the robot move freely. If this happen inside a narrow path area, add a perimeter island to eliminate the robot to drive into this area while mowing. Watch the below link: For RS / MS: How to set a Narrow Pass installation For RC / MC: How to set a Narrow Pass installation |
Stuck In Place (63) | RS/MS | Robot is stuck in place without the ability to drive forward for more than 100 seconds. | Such scenario can happen when bumper pressed is detected each time the robot tries to drive forward. | Check the robot is not trapped by hard obstacle which anchors it in place. |
Stuck in place (7) | RS/MS RC/MC |
Robot is stuck in place without the ability to drive forward, but only turning around | Operate the robot manually ('Go' button) and observe the robot drives forward. If the robot turning around, a further investigation required by an authorized technician. Call Robomow Hotline. http://robomow.eu/ Contact us page |
|
Stuck in place (8) | RS/MS RC/MC |
Robot drives forward for long time without detecting wire or bumper event. After 250 meter (by the odometer), the robot will change direction, and if a 2nd leg will be the same, the robot will stop with this error message | Such scenario can happen when the robot starts to mow while Slippage readings are not detected at the beginning of the operation (first 2 legs), and the robot stuck with no ability to drive forward (e.g. drive wheels are not the air, or dig into the ground). | Check the robot's location when this error happened, to observe for no reason the robot stuck in that particular place. |